was added to the project list.
×

Drive-over LED in-ground luminaires

For illuminating vertical surfaces


The design of these in-ground floodlights makes it possible to fully illuminate a vertical surface, e.g. a façade, from the ground up to the lower edge of the roof. The lower limit of the light distribution is a straight line, without the usual “light cone”. The luminaires are mounted in a recessed housing on a foundation that absorbs the pressure loads. The foundation, including drainage, must be laid by the customer before installation.

The luminaires can be driven over by vehicles with pneumatic tyres. The luminaires must not be used in areas where they are exposed to horizontal loads caused by braking, accelerating and changes of direction.

more
Share

Pressure load 1000 kg
Material Cast aluminium
Protection class IP 67
Installation depth 110 mm
Size Ø 285 mm

BEGA Thermal Management ®

Cover made of cast aluminium
Luminaire housing made of cast aluminium
Installation housing made of stainless steel
Tempered crystal glass
Silicone diffusing lens
Reflector surface made of pure aluminium
Water stop · Connecting cable

DALI controllable

20-year availability guarantee for LED modules

The luminaire luminous flux and the luminaire connected wattage quoted in the table may change as a result of technical progress. On our website you will find data sheets with information on each luminaire concerning not only the current values but also the LED service life and the luminous flux in relation to the respective colour temperature.


Illuminating vertical surfaces from the ground up

The predecessor system of these new floodlights used discharge lamps as their light source and illuminated many prestigious structures around the globe. BEGA has decades of experience in the area of in-ground luminaires and LED technology, which have allowed the development of this new luminaire type in peerless quality. With careful and professional installation, these floodlights will perform their lighting tasks during very long operating times.

The in-ground floodlight is perfectly suited for applications in which an illumination of vertical surfaces is needed and where the luminaire should be installed at ground level and have drive-over capabilities. The cast aluminium luminaire is mounted in a stainless steel installation housing on a foundation that absorbs pressure loads of up to 1000 kg. The LED colour temperature can be set between 3000 K and 4000 K and the luminaire is DALI controllable.


The following table serves as a project planning aid. The arrangement of the luminaires can be derived from the size of the object to be illuminated and the required degree of illuminance.

Project planning aid A H B Ē Emin
84618

84175
LED 27.4 W 1.5 m 4.0 m 3.0 m 127 lx 21.0 lx
2.0 m 6.0 m 4.5 m 56 lx 10.5 lx
3.0 m 8.0 m 6.0 m 32 lx 6.0 lx

A – Distance of the luminaires to the façade

H – Height of the façade

B – Distance between the luminaires

Ē – Average degree of illuminance on the façade

Emin – Minimum degree of illuminance


LED colour temperature
  LED Power supply unit A B C D
84 618 K3   27.4 W 2336 lm DALI controllable Ø 285 345 110 60
no longer included in the current catalogue new in the range

Drive-over LED in-ground luminaires in use